







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Home Additions & ADU: The Hialeah Owner’s Guide
We build Toto-compatible home additions and ADUs in Hialeah. Home additions typically run $45,000 – $130,000; a full ADU runs $90,000 – $220,000. Both figures are installed prices, written before work begins.
This is not a parts page in the usual sense. Toto is a fixture and fittings brand, not a structural product. Homeowners in Hialeah who search “Toto” alongside a failed addition usually mean something specific: a Toto fixture is being relocated or roughed in as part of the new space, and the layout that worked in the old bathroom or kitchen does not translate cleanly to a new slab, a new wall, or a new wet wall. The other common scenario is a Toto toilet, sink, or fixture that has been sitting in a box for a remodel that stalled, and the homeowner wants it properly installed in the addition rather than fabricated around. In both cases the part isn’t failing. The plan underneath it is.
We’re an independent construction provider. Rowan Construction Group Hialeah is not affiliated with Toto, and we claim no stock of Toto parts on hand or on a truck. What we do is build the room a Toto fixture needs, to the rough-in dimensions Toto specifies.
Which Toto Models This Applies To

Toto’s residential lineup breaks into three families that matter to a home addition. The high-efficiency toilets (Aquia, Ultramax II, Drake) use a 12-inch rough-in as standard, with 10-inch and 14-inch variants for tight walls. Washlet and integrated bidet seats (S7, S550e, C5) need a dedicated GFCI-protected outlet within reach of the seat and a water supply line at a specific offset. Sink and faucet lines (the standard basin and widespread faucet families) follow a 1 3/8-inch faucet hole pattern, which is not universal across brands.
Identifying what you have means reading the label on the inside of the tank lid for toilets, or the model number stamped on the faucet shank or under the seat. Photograph it. If the fixture is still boxed, pull the spec sheet from the box and note the rough-in dimension and the water supply location before any wall goes up.
The OEM-vs-aftermarket question is different for an addition than for a repair. There’s no Toto part to swap. The relevant decision is whether to design the new bathroom or laundry around the rough-in your Toto fixture needs, or whether to buy a different fixture that fits the rough-in the addition already produced. We usually recommend the former. Fabricating around a landmark you already own is cheaper than re-piping a finished wall.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Toto Home Additions & ADU Is Failing
These are the real failure modes we see in Hialeah on additions where a Toto fixture is involved.
- The toilet rocks or the wax seal weeps. Usually a floor that isn’t level under the flange, or a rough-in measured to the finished tile rather than the subfloor. Toto’s Aquia and Drake need a solid, level base; a flange set 1/4 inch high is enough to break the seal within a few months.
- The Washlet trips the GFCI repeatedly. Often a missing dedicated circuit or a shared outlet with a hair dryer or exhaust fan. Toto’s integrated seats draw enough to overload a shared 15-amp circuit during a heated wash.
- Low water pressure at the Toto faucet after the addition. Almost always a supply line sized for the old fixture count, not the new one. Additions add fixtures; the trunk line has to carry them.
- Condensation on the outside of the tank or the fixture base. Hialeah’s humidity and the temperature differential between a cool supply line and a warm interior finish. In a new addition, this usually means the wet wall wasn’t insulated for our climate.
- A fixture that fits in the showroom doesn’t fit the finished room. Door swing, vanity depth, and toilet centerline clearance to a side wall are the three that bite. A 30-inch toilet space is the floor, not the goal.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

The right number for this page is the addition, not a part. Here is what the Hialeah market should look like, written into a flat quote before anyone starts.
| Scope | Installed range |
|---|---|
| Home addition (family room, primary suite, in-law space) | $45,000 – $130,000 |
| ADU construction (full detached or attached unit) | $90,000 – $220,000 |
| Garage conversion to living space | $30,000 – $80,000 | Bathroom fit-out inside the addition (Toto fixture install) | $9,000 – $28,000 |
What drives the range: foundation type (slab vs. raised), whether the project needs a new roof tie-in, how far the wet wall runs from the existing stack, and permit scope. Hialeah additions inside the 25-mph wind zone and the current flood maps carry construction requirements a dry-lot suburb doesn’t, and those show up in the number.
Every quote we write is a flat, line-item price with a written scope and a written warranty. We do not proceed on a change until you’ve signed a change order. That’s Clause 1 of the Haven Standard, and it’s why our projects finish within a few percent of the agreed cost. The 365-Day Done Right Promise backs every finished job.
DIY or Call Us?
Some things a homeowner can check safely. Whether the toilet flange sits flush with the finished floor. Whether the Washlet outlet is on its own GFCI circuit. Whether the supply line valves shut off cleanly and don’t weep. Whether the spec sheet’s rough-in dimension matches the measured distance from the finished wall to the flange bolts. Those four checks take an afternoon and rule out most of the problems that turn into a callback.
What goes wrong when owners go further: pulling a toilet on a new tile floor and cracking the flange, chasing a water-pressure problem into a supply line that needs re-sizing, or opening a wet wall that carries the addition’s insulation. We’ve fixed those trips. The repair costs more than the original check would have.
If you’re planning the addition and want the Toto fixture roughed in right the first time, call (888) 836-5914. Estimates are free, and we’ll write the price down before any work starts.
FAQs

A Toto toilet’s flush valve and fill valve typically last 8 to 12 years; the ceramic itself lasts decades. Hialeah’s humidity shortens the soft-goods lifespan a bit, and mineral content in local municipal supply wears the valves faster than soft water. Call (888) 836-5914 for a free estimate on the surrounding addition work; a standalone fixture repair is a smaller job than we take on.
Sometimes. A rough-in that’s off by a quarter inch can usually be corrected with a flange extension and a new wax ring. A rough-in off by two inches means moving the drain, which means opening the slab. We’ll tell you which one you’re facing after a site visit, in writing, before you decide.
A garage conversion runs 8 to 12 weeks. A full home addition runs 4 to 7 months depending on permitting, and a detached ADU runs 6 to 10 months. Hialeah permit review, not build time, is usually the longest stretch. Call (888) 836-5914 for a written timeline with your estimate.
We source Toto fixtures through authorized distributors as part of the addition scope, alongside KraftMaid and Cambria, and Silestone when the budget calls for quartz. You get the model number and the price line in the written quote, so you can verify the spec sheet yourself before signing. If you already own the fixture, we install what you have and warrant the install.
Written by the team at Rowan Construction Group Hialeah, serving Hialeah and nearby areas.
Call (888) 836-5914 to schedule your free estimate on your Toto-compatible addition or ADU in Hialeah. We bring a written price, a documented photo record on every visit, and technicians with up to 19 years of experience. The 365-Day Done Right Promise covers the finished work.












