







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Kitchen Remodeling: The Hialeah Owner’s Guide
We install Schluter-compatible kitchen remodeling in Hialeah, and a full kitchen remodel here typically runs $14,000 – $45,000 with the waterproofing and tile work priced as written line items before anything starts. Same-day service applies to diagnostic visits, not to installs: a failing membrane or loose tile gets looked at, documented, and priced – not rebuilt in an afternoon, because curing and flood-testing don’t work that way. Most Hialeah owners find out something is wrong when a grout line near the sink or dishwasher starts darkening, or when a tile in front of the range rocks underfoot and sounds hollow when tapped. On a 1970s or 1980s Hialeah kitchen, that’s usually moisture that got under the tile and had nowhere to go.
We’re Rowan Construction Group Hialeah, an independent contractor – not affiliated with Schluter Systems – and we install Schluter’s KERDI, DITRA and KERDI-BOARD systems as one material line among the fifty-plus we source, alongside KraftMaid and Wellborn cabinets and Cambria and Caesarstone countertops.
Key Takeaways
- A full Hialeah kitchen remodel runs $14,000 – $45,000; a small kitchen remodel $9,000 – $20,000.
- Schluter is a system, not a single part – the membrane, the band, the drain and the substrate all have to match.
- Florida’s slab moisture and seasonal humidity are what fail these installations first, not the tile.
- Written price before work starts, signed change orders, 365-Day Done Right Promise on the labor.
Which Schluter Models This Applies To

Schluter’s kitchen-relevant line is really four families, and the one you have decides which replacement part fits. DITRA is the uncoupling membrane for floor tile over plywood or slab. KERDI is the sheet waterproofing for walls, counters, and the wet zones behind the sink. KERDI-BOARD is the foam backer panel that replaces cement board on walls and island fronts. KERDI-LINE and KERDI-DRAIN handle linear and point drainage if your kitchen has a floor drain or wet bar sink.
Read the printing on the roll core or the panel edge before you order anything – Schluter stamps the product name and, on DITRA, the membrane thickness (DITRA-5M versus DITRA-25M are not interchangeable, and the thinner one isn’t meant for the same load). KERDI sheet comes in 5M, 10M and 25M roll widths as well as 39″ wide rolls, and the matching KERDI-BAND and KERDI-FIX sealant are what make the system warrantable. The compatibility gotcha that bites Hialeah owners: buying KERDI sheet but sealing it with a generic thin-set or an unmodified mortar instead of Schluter’s specified unmodified thin-set – the joint won’t bond, and the waterproofing is only as good as that seam.
On OEM versus aftermarket: Schluter’s own membranes and banding are the safe choice because the system warranty depends on matched components. Quality aftermarket uncoupling membranes exist and can work, but they don’t inherit Schluter’s warranty coverage, and your tile setter has to trust the assembly. For a Hialeah kitchen you’ll live in for a decade, the few hundred dollars’ difference isn’t where you save money.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Kitchen Remodeling Is Failing
The membrane itself rarely “wears out.” What fails is the seam, the penetration, or the bond to the slab. Here’s what that looks like in a Hialeah kitchen.
- Hollow-sounding tile in front of the sink or dishwasher. That’s the thin-set releasing from the membrane or the membrane releasing from the substrate – usually moisture tracking under an unsealed edge. Tap along the baseboard line and listen for the change in tone.
- Dark or receding grout in a straight line. Grout darkening along a single continuous line, especially where two floor fields meet, points to a failed KERDI-BAND seam wicking water sideways. It’s a seam problem, not a grout problem.
- Loose or lifting tile at the island perimeter. Islands move differently than the surrounding floor; if the DITRA wasn’t carried under the island or the perimeter wasn’t banded, that edge is the first thing to lift.
- A musty smell that returns after cleaning. In Hialeah’s humidity, trapped moisture under a waterproof layer has nowhere to evaporate. A smell that comes back within weeks of cleaning usually means water is sitting between the membrane and the slab.
- Efflorescence – a white, chalky bloom – at the counter backsplash or floor edge. That’s mineral salts pushed out by moisture migrating through the assembly. It’s the most reliable early signal that water is moving where it shouldn’t.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work actually costs in Hialeah, quoted as a flat written price before anyone picks up a tool. These are installed ranges, materials and labor together:
- Full kitchen remodel: $14,000 – $45,000
- Small kitchen remodel: $9,000 – $20,000
- Backsplash installation: $800 – $2,500
- Countertop installation: $2,000 – $6,500
- Cabinet installation: $4,000 – $13,000
- Kitchen island installation: $3,000 – $10,000
What drives the range: how much floor has to come up to reach sound substrate, whether the slab needs moisture mitigation before a new membrane goes down, and the tile you choose. A single failed seam repair sits at the low end; a floor tear-out and re-waterproof runs higher. The parts are a small slice of that number – the labor to remove, prep, flood-test and reinstall is the rest, and we show it as line items. Under Clause 1 of The Haven Standard, the price is written before anyone starts, and no change proceeds without a signed change order. The work carries our 365-Day Done Right Promise, and every visit includes a documented photo record – what we found, what we did – left with you.
DIY or Call Us?
Some of this you can safely check yourself, and some of it you should not touch. You can tap the floor listening for hollow spots, look for efflorescence, smell for mustiness, and read the product labels so you know what you’re dealing with. What we’d steer you away from: pulling up tile or membrane to “see what’s under it,” because a kitchen floor membrane isn’t dangerous like a garage spring, but once you break the waterproofing layer on a slab, you’ve turned a repair into a full tear-out and the moisture problem gets worse before it gets better. Cutting into a KERDI seam without re-banding and flood-testing it properly leaves it more vulnerable than it was.
We don’t claim to stock parts or carry membrane on a truck – none of the trade works that way. What we do is identify the exact Schluter system you have, quote the repair or the remodel in writing, and install it to spec. Call (888) 836-5914 and we’ll get a free estimate on the calendar.
FAQs

A correctly installed Schluter membrane over a properly prepped substrate should hold for the life of the tile – think 20-plus years – because the membrane is inert and doesn’t rot or degrade. What shortens it in Hialeah specifically is slab moisture and the wet season’s humidity pushing vapor through an unmitigated slab. If the membrane was installed over a slab with no vapor barrier and no moisture test, the clock runs faster. Call (888) 836-5914 for a free estimate that includes a moisture check.
Sometimes – a single failed KERDI-BAND seam or a compromised penetration can be cut back, re-banded and spot flood-tested without tearing up the whole floor. It depends on how far the water traveled before anyone noticed. A hollow-sounding field of tile means the damage spread, and a patch won’t hold. We’ll tell you honestly which one you’re looking at, in writing, before any work starts.
A localized seam repair is usually a two-visit job – one to open, dry and document, a second to re-membrane, band and test – rather than a single afternoon, because the assembly has to dry and the waterproofing has to cure before tile goes back. A full kitchen remodel with new floor waterproofing runs several weeks depending on scope. Your written quote carries the realistic schedule, not a sales promise.
We source through established distribution for Schluter’s membrane, banding, sealant and drain lines, matched to the system already in your kitchen, and we name the exact product and size in the written scope so you can verify it. We don’t stock parts and we don’t carry them on a truck – we order what the job specifies. Bring us a competitor’s written estimate and we’ll review it line by line at no charge as a free second opinion.
Call (888) 836-5914 for a free estimate – written price before any work starts, the 365-Day Done Right Promise behind it, and a documented photo record when we leave. Serving Hialeah, Hialeah Gardens, Miami Lakes and the surrounding neighborhoods.
Written by the team at Rowan Construction Group Hialeah, serving Hialeah and nearby areas.












