







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Driveway & Pavers: The Hialeah Owner’s Guide
If you own a CGI paver driveway or paver patio in Hialeah, a failing base or loose field is usually the first thing you notice, not the pavers themselves. Most CGI paver installations we replace in Hialeah fall into the $7,000 – $18,000 range for a full driveway, with smaller patio sections between $3,500 – $11,000; resealing runs $250 – $700. We install CGI-compatible pavers and paver-base systems for Hialeah homeowners as an independent contractor, not as an authorized CGI dealer, and we’ll say so plainly: we buy the same joint sand, edge restraint and base aggregate that CGI jobs spec, from Belgard and Techo-Bloc lines where the spec calls for it.
The symptom picture is consistent. Hialeah owners call us after noticing a low spot that holds water through the wet season, then a paver that rocks underfoot, then sand washing out at the joints after a heavy rain. By the time the edge course shifts, the failure has usually been building in the base for a year or more. Under Clause 1 of the Haven Standard, we write the price before anyone picks up a tool.
Which CGI Models This Applies To

CGI’s paver and hardscape line covers both interlocking concrete pavers and segmental retaining wall systems, and the model naming follows their spec sheets, not a consumer catalog. The practical way to match your job is by paver dimensions, thickness and joint width, not by a CGI “model number” stamped on the unit. Standard field pavers in Hialeah driveways are typically 60mm or 80mm thick, and driveways that see regular vehicle traffic need 80mm in most CGI specs; 60mm is the patio gauge and will crack under a truck.
Measuring matters more than brand-hunting. Pull a loose paver and measure length, width, thickness and the chamfer. Note whether the joint sand is polymeric or plain, because a polymeric re-sand over a failed base just locks the failure in. For the OEM-vs-aftermarket call: CGI’s own units match existing courses exactly, which matters on a repair where the new pavers abut old. Aftermarket concrete pavers from a comparable spec line are dimensionally compatible on a full-field replacement and often cost the most honest number per square foot. We also handle KraftMaid, Cambria and Silestone across our other trades, but for pavers we source through Belgard and Techo-Bloc lines that spec-match your CGI field and stay in your written quote.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Driveway & Pavers Is Failing
- Paver rocking underfoot. The bedding sand has migrated out from under the unit. Once a paver moves, joint sand cannot hold the field and the neighbor pavers start moving next.
- Sand washing out of the joints. Hialeah’s wet season pushes water through joints that were never fully locked, and the sand loss accelerates once the base drains poorly. This is the earliest cheap-to-fix symptom and the one most owners ignore longest.
- Water ponding in a low spot. The base aggregate has settled or was never compacted in lifts. Ponding then freezes on nothing (this is Hialeah, not the north), but the standing water does drive organic staining and joint erosion.
- Edge course heaving or spreading. Edge restraint has separated from the subgrade or was never set on concrete. The field spreads outward, joints open, and the driveway loses its line.
- Efflorescence and color fade. Calcium salts wicking to the surface, common on new concrete pavers in South Florida humidity, or UV fade on a field that was never sealed. Cosmetic on its own, but a hint the field is holding water.
Replacement Cost & What’s Included

Installed pricing in Hialeah for the CGI-compatible paver work we run:
- Paver driveway installation: $7,000 – $18,000
- Driveway replacement (removal and reinstall): $5,000 – $14,000
- Paver patio installation: $3,500 – $11,000
- Driveway sealing: $250 – $700
- Concrete driveway installation, if you’re comparing: $4,500 – $12,000
What drives the range: square footage, thickness (60mm vs 80mm), base depth, whether old pavers and base get hauled off, and whether the edge restraint needs a fresh concrete curb. The quote is a flat written price with a written scope and a written warranty, and no change proceeds until the change order is signed. The 365-Day Done Right Promise applies to the work.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check several things yourself. Measure the paver, note where the water ponds, confirm whether sand is plain or polymeric, and lift one loosened unit to look at the base below. That’s honest inspection, not repair. Where DIY goes wrong on a paver field: re-sanding a settled base only hides the failure, and a partial re-lay without a compacted base lifts again within a season. Setting edge restraint on a fresh curb, compacting base aggregate in lifts, and matching thickness so the whole field bears vehicle weight are the steps that decide whether the job lasts. For that, and for a written price before any work starts, call (888) 836-5914. Bring a competitor’s quote and we’ll review it line by line free.
FAQs

A properly installed CGI paver field lasts 25 to 30 years in Hialeah’s climate, but the pavers aren’t the weak point; the base is. Heat, humidity and the wet season stress the joint sand and base drainage far more than the concrete units. Call (888) 836-5914 for an exact quote on your field; the estimate is free.
Often yes, on a localized failure: a single settled area, a heaving edge course, or washed-out joints can be reset and re-sanded if the base underneath is still compacted and draining. A field with ponding across multiple spots or spreading edges usually needs a full base rework, not patchwork. We’ll show you in the photo record exactly what we found before quoting either way, and call (888) 836-5914 to schedule the walkthrough.
Most Hialeah driveways run three to five working days once the base is opened: removal, base re-compaction, edge restraint, field install and joint sand. Patios typically finish in two to three days. The timeline goes in the written scope before work starts, and no change moves without a signed change order.
We match the paver by dimension, thickness and joint spec, then source CGI-compatible units through our vetted Belgard and Techo-Bloc lines, or order the exact CGI unit where a repair needs to abut existing courses. We don’t stock pavers and we don’t carry parts on a truck; the material is ordered to the job. Call (888) 836-5914 to get the written price before anyone starts.
Get Your Written Price
If you’re looking at a CGI paver driveway in Hialeah and want the number before anyone touches the field, call (888) 836-5914 for a free estimate. You’ll get a written price with a written scope, a documented photo record from the visit, and the 365-Day Done Right Promise in writing. Our technicians have up to 19 years of experience, and every crew member is background-checked and uniformed. Reach out today for a free second opinion on any written estimate you already have.
Written by the team at Rowan Construction Group Hialeah, serving Hialeah and nearby areas.












