







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling: The Hialeah Owner’s Guide
We install Toto-compatible bathroom fixtures and full bathroom remodeling for Hialeah homeowners, with most complete bathroom projects landing between $9,000 and $28,000 installed. Repair and replacement of a single failed Toto part (a fill valve, flush valve, seat, or supply line) is scheduled as a planned visit, usually within the same week you call. Our technicians have up to 19 years of experience with Toto’s residential lines.
Most Hialeah owners find the problem the same way: the toilet runs for ten seconds after every flush, or the tank never fully refills, or a slow seep shows up as a soft ring at the base of the bowl. A Toto that has been quiet for years suddenly isn’t. That’s the moment this page is written for. Have the model number ready when you call (888) 836-5914, and we can price the part and the labor before anyone picks up a tool.
Key Takeaways
- Full Toto bathroom remodels in Hialeah run $9,000 – $28,000 installed; a single fixture repair is a fraction of that.
- Toto’s fill and flush valves are model-specific. The right part for a Drake is not the right part for a Vespin II or a Neorest.
- Florida’s hard water and year-round humidity wear rubber seals faster than the national average. Expect to replace fill valves more often here.
- Rowan Construction Group Hialeah is an independent service provider. We are not affiliated with Toto.
Which Toto Models This Applies To

Toto’s residential toilets split into a few families, and the internals do not cross over cleanly. The Drake line (CST743, CST744, and the Drake II CST454) uses a fill valve and flapper that are widely available and inexpensive to service. The Eco Drake and Ultramax add a different tank geometry. The Vespin II uses Toto’s Double Cyclone flush, which changes the trapway and the flush tower assembly. And the Neorest and Washlet lines are integrated electronic bidet seats, where the “part” might be a solenoid, a seat sensor, or the control board rather than a mechanical valve.
Identify your model two ways. First, lift the tank lid and look for a label on the inside of the tank wall or underneath the lid itself; Toto prints the model number and sometimes the fill-valve part number there. Second, measure the rough-in: the distance from the finished back wall to the center of the closet bolts. Toto’s standard residential rough-in is 12 inches, but 10-inch and 14-inch versions exist and take different bowls. Getting the rough-in wrong is the single most common mistake we correct on a Hialeah install, because a bowl that sits proud of the wall or crowds it is a rebuild, not a swap.
For the OEM-versus-aftermarket decision: Toto’s own fill valves and flush towers hold up well and are worth the premium on a Neorest or Vespin II, where the tolerances are tight. On a standard Drake, a quality aftermarket fill valve (Fluidmaster, Korky) is a legitimate, widely stocked equivalent, and we’ll tell you plainly which one we recommend and why. We don’t claim to stock parts or carry them on a truck; we source the correct part for your model and bring it to the job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Toto Bathroom Remodeling Is Failing
The symptoms are specific, and each points to a different internal part. Here’s what to listen and look for.
- The toilet runs for several seconds after the flush. The flapper or flush-tower seal isn’t seating, so water trickles from the tank into the bowl and the fill valve keeps topping it off. In Hialeah’s hard water, mineral film on the seal is a frequent cause.
- The tank never fully refills, or refills slowly. The fill valve is clogged with sediment or its diaphragm has stiffened. A slow fill that used to take 30 seconds and now takes several minutes is a valve on its way out.
- A soft ring or damp spot at the base of the bowl. The wax ring or the bowl-to-flange seal has failed. This is the one to address quickly; a slow leak under a tile floor is a far more expensive problem than a $5 wax ring.
- A rocking or loose bowl. The closet bolts have loosened or the flange itself is cracked. On a Hialeah install, we check the flange condition before setting any bowl, because a cracked flange means the toilet won’t stay tight no matter how well you re-seat it.
- The Neorest or Washlet seat won’t heat, won’t spray, or cycles oddly. On electronic Toto fixtures, this is usually the control board, a solenoid, or a sensor, not a mechanical valve. These we diagnose before quoting, because the part cost varies widely by model.
Replacement Cost & What’s Included

Here are the price ranges for Toto work in Hialeah, using our standard written-quote pricing:
- Full bathroom remodel with Toto fixtures: $9,000 – $28,000 installed
- Small bathroom remodel: $5,000 – $12,000
- Tub-to-shower conversion: $3,500 – $10,000
- Walk-in shower installation: $4,500 – $12,000
- Bathroom vanity installation (Toto or other): $800 – $3,000
The range is driven by scope, not by the Toto name. A straightforward toilet or valve replacement is a small, fixed labor charge; a full remodel – new tile, a walk-in shower, a Toto vanity or bidet seat – moves the number up. Every quote is a flat written price with a written scope, delivered before any work starts. Parts and labor are itemized. Nothing changes on the job without a signed change order, so the number you agree to is the number you pay, within a few percent. Our work is backed by the 365-Day Done Right Promise under The Haven Standard: if it isn’t done right, we make it right. Bring a competitor’s written estimate and we’ll review it line by line at no charge – the Free Second Opinion is a standing offer.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this you can safely check yourself. Some of it you shouldn’t touch. Filling the tank, watching where the water comes from, listening for a running valve, and reading the model label inside the tank are all things any homeowner can do without risk. Replacing a wax ring, re-setting a bowl, and diagnosing a Neorest control board are where DIY goes wrong. The wax ring is the one safety note worth stating plainly: a poorly seated bowl leaks under the floor for weeks before you see it, and by then you’re replacing subfloor, not a seal. And on any electronic Toto fixture, the electrical components are not a place to experiment. If you’ve listened, looked, and read the label and you’re still not sure, that’s the point to call (888) 836-5914. The call costs nothing, and an estimate is free.
FAQs

How long does a Toto fill valve or flush valve last in Hialeah? A Toto fill valve typically lasts 5 to 7 years in Hialeah’s hard water, noticeably shorter than in softer-water regions, because mineral buildup stiffens the rubber diaphragm faster. Flush-tower seals often go sooner. If yours is original to a toilet installed in the last decade, routine replacement is a reasonable plan, not a surprise.
Can the part be repaired instead of replaced? Sometimes, yes. A flapper that isn’t sealing can often be cleaned of mineral film and re-seated; a fill valve with a clogged screen can sometimes be cleared. But a stiffened diaphragm or a cracked flush tower usually can’t be repaired reliably, and a cheap repair that fails in a month costs more than the right part done once. We’ll tell you honestly which side of that line your Toto is on.
How long does the swap take? A standard fill valve or flapper replacement is a short visit, often under an hour once the correct part is in hand. A wax-ring and bowl re-set is a bit longer because the bowl comes off and the flange gets inspected. Neorest electronics take longer to diagnose before we can quote the part. We confirm the scope and the price before we start.
How do you source the correct Toto part? We read your model number off the tank label and match it against Toto’s part breakdown for that exact series (Drake, Eco Drake, Vespin II, Neorest, and so on), confirm the rough-in measurement, and source the correct OEM or approved aftermarket part. We don’t claim to stock parts; we source the right one for your model and bring it. We also service fixtures from KraftMaid, Cambria, and Silestone when a remodel involves cabinets or countertops alongside the Toto work. Call (888) 836-5914 for a free estimate on any of it.
Schedule Your Toto Bathroom Remodeling Estimate in Hialeah
Whether it’s a single failing valve on a Drake or a full bathroom remodel built around Toto fixtures, the next step is the same: a written price before any work begins. Call (888) 836-5914 for a free estimate. Our technicians have up to 19 years of experience, calls are answered by a live person, and every visit includes a documented photo record of what we found and what we did. Rowan Construction Group Hialeah is an independent service provider and is not affiliated with Toto.
Written by the team at Rowan Construction Group Hialeah, serving Hialeah and nearby areas.












